Heat a plate with a hole
"Heat a plate with a hole" is a free, interactive Class 11 Physics simulation for NEET and JEE, built on the NCERT section "Thermal expansion" in Thermal Properties of Matter. A plate with a hole heated: every length grows by αΔT, so the hole grows; area and volume change with 2α and 3α. NEET has asked about this idea 2 times in 10 years of papers. JEE Main asked 21 questions from this chapter across the 42 shifts Lumi has analysed (2017–2026).
From the lesson Thermal expansion in Thermal Properties of Matter. Change the values and watch what happens.
What it shows
NCERT §10.5
A plate with a hole heated: every length grows by αΔT, so the hole grows; area and volume change with 2α and 3α.
Controls
4 to try
- SliderΔT 0–500 K
- Togglematerial (Al, Cu, iron, invar)
- Togglerod / plate with hole / cube
- Toggleexaggerate ×1000
Try this
Heat an aluminium plate until its hole's area grows by 1 % (ΔT ≈ 200 K).
Common mistake
The hole shrinks as the metal expands into it; using α for area or volume.
In NEET
10 years of papers
Asked 2 times in 10 years of NEET.
See the past questions: Heat Transfer and Thermal Expansion, Thermal Properties of Matter (chapter)
In JEE Main
42 shifts analysed
21 questions from Thermal Properties of Matter across the 42 JEE Main shifts Lumi has analysed (2017–2026).
The idea behind it
NCERT §10.5
- Most substances expand when heated and contract when cooled; the rise in size is thermal expansion. A tight metal lid loosens under hot water, mercury climbs a thermometer, and a partly blown balloon in warm water swells.
- Linear expansion: a rod of length l grows by Δl when its temperature rises by ΔT, with Δl/l = α_l ΔT. α_l is the coefficient of linear expansion, a property of the material.
- α_l in units of 10⁻⁵ K⁻¹, smallest first: lead 0.29, pyrex glass 0.32, iron 1.2, gold 1.4, copper 1.7, brass 1.8, silver 1.9, aluminium 2.5. Metals expand more than glass: copper about five times pyrex.
- Area expansion: a flat sheet's area grows by Δa/a = 2α_l ΔT, so the coefficient of area expansion is 2α_l.
- Volume expansion: ΔV/V = α_V ΔT, with α_V the coefficient of volume expansion. It is not strictly a constant: it depends on temperature and levels off only at high temperature, as the curve for copper shows.
- α_V in K⁻¹: aluminium 7 × 10⁻⁵, brass 6 × 10⁻⁵, iron 3.55 × 10⁻⁵, glass (ordinary) 2.5 × 10⁻⁵, pyrex 1 × 10⁻⁵, hard rubber 2.4 × 10⁻⁴, invar 2 × 10⁻⁶, paraffin 58.8 × 10⁻⁵, mercury 18.2 × 10⁻⁵, water 20.7 × 10⁻⁵, ethanol 110 × 10⁻⁵.
- For an isotropic solid α_V = 3α_l: a cube of side l heated by ΔT becomes (l + Δl)³ ≈ l³ + 3l²Δl, so ΔV/V = 3Δl/l = 3α_l ΔT.
- Gases expand far more than solids or liquids. For an ideal gas at constant pressure PΔV = μRΔT, which gives α_V = 1/T: about 3.7 × 10⁻³ K⁻¹ at 0 °C, falling as T rises, and about 3300 × 10⁻⁶ K⁻¹ near room temperature, much larger than for any solid or liquid.
- A thin plate expands like a magnified photograph: a hole in it grows too, because every length in the plate grows in the same ratio.
Questions
5 answers
- What does the "Heat a plate with a hole" simulation show?
- A plate with a hole heated: every length grows by αΔT, so the hole grows; area and volume change with 2α and 3α.
- What mistake does the "Heat a plate with a hole" simulation fix?
- A common mistake it clears up: the hole shrinks as the metal expands into it; using α for area or volume.
- Has NEET asked about this idea?
- Yes. NEET has asked about this idea 2 times in 10 years of papers.
- Does JEE Main ask questions from Thermal Properties of Matter?
- Yes. JEE Main asked 21 questions from this chapter across the 42 shifts Lumi has analysed (2017–2026).
- Is this simulation free?
- Yes. It is free and runs in the browser on a phone or a laptop. It belongs to the lesson "Thermal expansion" in Thermal Properties of Matter (Class 11 Physics).
Embed this simulation
Free, with a link back
Teaching this idea? Put the simulation on your own page or LMS with this code.